How To Repair The Treyo Mahjong Machine
Sep 28, 2021
1. The conveyor belt wheel dice sounds
The cause of the failure: the rusty pillars of the conveyor wheel and dice are caused by rusting. Just remove the mahjong machine wheels to remove the embroidery powder and refuel.
2. The last few cards cannot be shuffled
The cause of the failure: the spring is off or the card is not good, there is no magnet, or the position of the magnetic coil motor is adjusted, the magnet of the flop is not good or the position is not good, whether the magnetic coil and the large plate are synchronized, and the rubber strip is off.
3. Conveyor belt slips and runs sideways
The cause of the fault: the tension rod of the conveyor belt is not strong enough. At this time, you can withdraw the tension spring screw to the next screw hole or replace the spring to eliminate it; the driving wheel of the conveyor motor is deformed.
4. Sometimes there are flops on the conveying trough
Cause of failure: This phenomenon is mainly due to the adjustment of the high and low positions of the magnetic ring and the conveying groove. The upper and lower positions of the magnetic ring and the conveying groove are best to be 1mm. At this time, only the small magnetic ring carrier wheel gasket needs to be reduced or the conveying groove can be raised. . (Note: When raising the conveying trough, pay attention to the distance between the front of the conveying trough and the machine head).
5. The chain bar is stuck behind the push board
The cause of the failure: the flexibility of the Sifang card stick back and forth, whether the top of the Sifang card pressing board falls off, whether the tension spring has fallen off or is broken, the microswitch is not flexible.
6. The cards washed on the table are not neat and scattered
The cause of the failure: the distance of the card transport track is too large, and the overall screw of the road board is loose. The card pushing slider is not very flexible, and the card tabletop phenomenon occurs when the card is being upgraded.
7. The card making speed of the machine is slower than 80 seconds
The cause of the failure: the position of the magnetic ring is not in place, the rubber strip of the turntable falls off, the adjustment of the triangle block distance, the adjustment of the card feeder, the adjustment of the flip strip, the height adjustment of the magnetic isolation plate and the turntable, the speed of the machine head is abnormal, and the conveying groove There is debris, the shuffle spring is not easy to use, and the speed of the turntable is ahead of the magnetic coil.
8. Head card
The reasons for the failure are: adjustment of the stroke position of the machine head and the conveying trough (generally, the distance between the top plate of the machine head and the conveying trough is 1 mm on the diagonal of the mahjong card, which is the maximum), the poor performance of the trough-shaped optocoupler, and the K1 machine head sensor The light-sensitive distance is too long (the sensing distance of 4# light sensor is 10mm), the motor gear is damaged, and the machine head stacker is not level with the road plate. Adjust the position of the stop plate and the push plate of the machine head. The push slide of the first class is not flexible enough to retreat, and the stainless steel plate is too low.
9. The card-up table is not level with the desktop
The reasons for the failure are: the rubber pad is not placed correctly or the upright rocker arm is not vertical, the screws are loose, or the blocking iron plate is too high or too low, the panel bracket screws are loose, and the panel is deformed.
10. The middle control tray is not flat with the desktop
The cause of the failure: the height adjustment screw of the lifting plate in the electric control box is loose. If the screw is not loose, it is caused by the deformation of the panel.
